During startup, acceleration or when climbing hills – any time high power output is required – the engine operates on all six cylinders. During moderate speed cruising and at low engine loads, the system operates just one bank of three cylinders. For moderate acceleration, higher-speed cruising and mild hills, the engine operates on four cylinders.

With three operating modes, the VCM system can finely tailor the working displacement of the engine to match the driving requirements from moment to moment. Since the system automatically closes both the intake and exhaust valves of the cylinders that are not used, pumping losses associated with intake and exhaust are eliminated and fuel economy increases. The VCM system combines maximum performance and maximum fuel economy – two characteristics that do not typically coexist in conventional engines.

VCM deactivates specific cylinders by using the VTEC (Variable Valve-Timing and Lift Electronic Control) system to close the intake and exhaust valves while simultaneously the Powertrain Control Module cuts fuel to those cylinders. When operating on three cylinders, the rear cylinder bank is shut down. When running on four cylinders, the left and center cylinders of the front bank operate, and the right and center cylinders of the rear bank operate. The spark plugs continue to fire in inactive cylinders to minimize plug temperature loss and prevent fouling induced from incomplete combustion during cylinder re-activation.

The system is electronically controlled, and uses special integrated spool valves that do double duty as rocker-shaft holders in the cylinder heads. Based on commands from the system's electronic control unit, the spool valves selectively direct oil pressure to the rocker arms for specific cylinders. This oil pressure in turn drives synchronizing pistons that connect and disconnect the rocker arms.

The VCM system monitors throttle position, vehicle speed, engine speed, automatic-transmission gear selection and other factors to determine the correct cylinder activation scheme for the operating conditions. In addition, the system determines whether engine oil pressure is suitable for VCM switching and whether catalytic-converter temperature will remain in the proper range. To smooth the transition between activating or deactivating cylinders, the system adjusts ignition timing, drive-by-wire throttle position and turns the torque converter lock-up on and off. As a result, the transition between three-, four-, and six-cylinder operation is unnoticeable to the driver.

Active Control Engine Mount (ACM) and Active Noise Control (ANC)
The ACM system is used to minimize the effects of engine vibration as the VCM system switches cylinders on and off. Sensors alert the Electronic Control Unit (ECU) to direct ACM actuators positioned at the front and rear of the engine to move to cancel engine vibration. Inside the interior of the Pilot, the ANC system works in cooperation with the ACM system to further reduce any sound relating to the function of the VCM system. (Please see the Interior tab for more information.)

Drive-By-Wire (DBW) Throttle System™
The drive-by-wire throttle system uses smart electronics instead of a conventional cable system to connect the throttle pedal to the throttle butterfly in the intake tract. Besides allowing engineers to program the relationship between throttle pedal movement and engine response, the system optimizes engine response to suit driving conditions. The system monitors throttle pedal position, throttle butterfly position, road speed, engine speed and engine vacuum. This information is used to define the throttle control sensitivity.